AP 모델명 : Aruba AP-515
AP Controller : Aruba 7030
// dhcp 뿌려주는 환경이면 콘솔 세팅 필요없이 바로 컨트롤러 연결 가능
1. PC와 AP를 콘솔 케이블로 연결 (Baud rate : 9600)
2. AP 전원 연결 후 부팅 메시지 올라올 때 Hit <Enter> to stop autoboot:0 문구 나올때 엔터 엔터
DDR test done successfully
Loading image 0...
Validating image 0...
Uncompressing image 0...
Booting image 0...
APBoot 2.4.1.18 (build 67717)
Built: 2018-11-09 at 14:43:46
Model: AP-51x
DRAM: 1 GiB
NAND: ECC BCH-8, ONFI, Manuf ID: 0xef, Chip ID: 0xf1 (Winbond W29N01HV), page size: 2048, OOB size: 64, device size: 128 MiB
PCIE1: link up
PCIE2: link up
Power: 802.3at POE
In: serial
Out: serial
Err: serial
Net: eth0
Radio: bcm43694#0, bcm43694#1
Reset: cold
FIPS: passed
Hit <Enter> to stop autoboot: 0 <---- enter 버튼
3. 프롬프트가 apboot> 로 바뀌면 성공
4. AP 설정
apboot> setenv ipaddr x.x.x.x // AP에 할당할 IP
apboot> setenv netmask x.x.x.x // 서브넷 마스크
apboot> setenv gatewayip x.x.x.x // 게이트웨이 IP
apboot> setenv master x.x.x.x // 컨트롤러 IP
apboot> saveenv // 설정값 저장 (필수)
apboot> printenv // 설정값 확인
apboot > boot // 부팅
댓글